Even, glare-free light from slim LED fixtures
Recessed Lighting Installation in Orem, UT, Often Done Same Day
Dark kitchens and dim basements are a common complaint in older Orem homes. Recessed lighting sits flush with the ceiling, lights the whole room evenly and makes it feel bigger. Our electricians plan the layout, cut clean holes and wire everything to smooth dimmers. Scheduling is fast, often within days, with same day estimates when we have an open slot. Emergency at night? An electrician near you answers 24 hours a day.
Canless wafer lights or traditional cans?
Most new installs today use slim canless LEDs. Cans still have a place. Here is the difference.
| Feature | Canless wafer LED | Traditional can light |
|---|---|---|
| Depth | About an inch thick, fits tight spaces | Needs several inches above the ceiling |
| Install in finished ceilings | Easy, through a small round hole | Harder, larger housing |
| Bulb changes | No bulb, long-life LED | Swappable trims and bulbs |
| Attic insulation | Most are IC-rated | Must use IC-rated housings |
| Best for | Remodels, basements, most rooms | Special trims, adjustable beams |
Getting the layout right
Too few lights leave dark corners. Too many feel like an office. We plan with you, room by room.
- Kitchens: lights over counters, not behind you, so you don't cast shadows on your work.
- Basements: even rows for low ceilings, paired with dimmers for movie nights.
- Living rooms: lights that wash walls and art, not just the floor.
- Hallways: fewer, well-spaced lights on a three-way switch.
Building out a basement? See Basement Finishing Electrical.
Choosing light color and brightness
Color temperature is measured in Kelvin. It changes the whole feel of a room.
2700K, warm white
Cozy and soft. Great for living rooms and bedrooms.
3000K, soft white
Warm but crisp. A favorite for kitchens and baths.
4000K, cool white
Bright and clear. Good for garages, laundry and work areas.
Color-select fixtures
Many Halo fixtures let you switch color with a small dial, so you can choose after install.
How we install recessed lights in a finished ceiling
Most rooms are done in a single visit with very little dust.
Mark and check
We mark each spot and check for joists, ducts and pipes.
Cut and wire
Clean round holes, new wire fished between lights, a new switch box if needed.
Mount and dim
Fixtures snap in, then we add an LED-rated dimmer such as Lutron.
Test and tidy
We test every light at full and low dim, and clean up.
Pair your new lights with these
Lighting looks best with the right controls and fixtures.
Helpful guides from our blog
- LightingHow to Choose LED Bulbs
- SeasonalWinter Electrical Safety Tips
Recessed lighting questions
Can you add recessed lights to an existing ceiling?
Yes. Canless wafer lights are made for this. We fish wire through the ceiling and install through small round holes.
How many recessed lights do I need?
It depends on room size, ceiling height and use. We plan spacing so light overlaps evenly with no dark spots.
Are recessed lights safe near attic insulation?
Yes, when they are IC-rated. We only install IC-rated fixtures where they touch insulation.
Can recessed lights be dimmed?
Yes, with an LED-rated dimmer. The right dimmer prevents flicker and buzzing.
Do LED recessed lights save energy?
Yes. LED fixtures use far less power than old incandescent cans and last much longer.
What color temperature should I pick?
Many homeowners choose 2700K to 3000K for living spaces and 4000K for garages and work areas.
Ready for a brighter room?
We plan the layout, install the lights and add smooth dimmers, usually in one visit.
Licensed through Utah DOPL and fully insured. Learn about our team.